Stars & Stripes Sale on American-Made MuscleShop Now

Torker II EFI Pontiac Intake Manifold

was $473.95 Special Price $426.56
Edelbrock Torker II EFI Pontiac Intake Manifold for Pontiac 326-455 V8
In stock
SKU
50565
The Edelbrock Torker II Pontiac #50565 EFI intake manifold is designed for 1965-79 street 389-455 c.i.d. Pontiac V8's. Can be used with Ram Air IV heads. Will not fit Ram Air V and 265/301 V8's or under Trans Am Shaker hood. The Edelbrock Torker II Pontiac #50565 also features a natural aluminum finish for a classic look. For the ultimate "Made in USA" quality, every Edelbrock intake manifold is cast and machined in the USA.

Installation Notes:
• Recommended intake gasket: Edelbrock #7280
• Manifold height: 1-1/4" taller than stock, A-6.88", B-8.00" measured to engine block
• Throttle body pad height: 7.45"
• Port exit dimensions: 1.10" x 2.06"
• For 1968-71 use Edelbrock #8015 throttle bracket
• Use RTV sealant to properly seal end seals, such as Edelbrock High Temp Silicone sealant #1076, DO NOT USE END SEALS GASKETS.
• Hardened washers Must be used with intake bolts to ensure proper torque and prevent galling of the aluminum.
More Information
Manufacturer Edelbrock
Application Application Specific
UPC 00085347505654
Series Torker/Torker II
Grade Type Performance
Gasket Or Seal Included No
Vehicle Model Pontiac
Availability Note Available to Order
Warranty 12 Months
RPM Range 2500-6500 RPM
Emissions Code
Hazardous Materials Warning WARNING: This product can expose you to Lead, which is known to the State of California to cause cancer or birth defects or other reproductive harm. For more information, visit www.P65warnings.ca.gov.
Color Satin
Material Aluminum
Rear Maximum Height 7.150 in
Single Or Dual Plane Type Single