The store will not work correctly when cookies are disabled.
We use cookies to provide you with the best possible user experience. By continuing to use our site, you agree to their use. To learn more, view our
Cookie Policy.
Edelbrock Torker 308 Intake Manifold for Small-Block Holden Engines is Designed for 253-304-308 C.I.D. V8's with Red Motor Cylinder Heads. Will Not Fit Black/Blue Cylinder Heads. Accepts a 4150-Style Square-Bore Carburetor. Non-EGR.
The Edelbrock Torker 308 #2790 intake manifold is designed for Holden 253-304-308 c.i.d. V8 engines with Red motor cylinder heads only (with single bolt in center of manifold), will not fit on Blue/Black cylinder head engines. The Torker 308 intake manifold is a single-plane design and is recommended for street high performance and race engines operating between the 2500 to 6500 rpm range where low-end torque is not required. Accepts square-bore carbs only. The Edelbrock Torker 308 #2790 also features a natural aluminum finish for a classic look. For the ultimate "Made in USA" quality, every Edelbrock intake manifold is cast and machined in the USA.
Installation Notes: • Do not use competition style intake gaskets for this street manifold. Due to material deterioration over time, internal leakage of vacuum, oil, and coolant may occur. • Recommended intake gasket: OEM equivalent. • Manifold height: A-2.95”, B-4.50” • Carb pad height: 3.73” • Port exit dimensions: 1.03” x 1.88” • Use RTV sealant to properly seal end seals, such as Edelbrock High Temp Silicone sealant #1076, DO NOT USE END SEALS GASKETS. • Hardened washers Must be used with intake bolts to ensure proper torque and prevent galling of the aluminum.
WARNING: This product can expose you to Lead, which is known to the State of California to cause cancer or birth defects or other reproductive harm. For more information, visit www.P65warnings.ca.gov.