Skip to the beginning of the images gallery

Performer RPM Engine Camshaft And Lifter Kit #7122 For Small-Block Ford 289-302 V8

$428.95

Edelbrock part #7122 Performer RPM Camshaft is designed for small-block Ford 289-302 V-8 applications. This Edelbrock cam kit produced 367 HP & 340 ft-lbs. of torque when used with #7121 intake and #60259 cylinder heads on a 302 engine.

TEMPORARILY OUT OF STOCK

SKU

7122

Details

Edelbrock Part # 7122 Performer RPM Camshaft is designed for small-block Ford 289-302 V-8 applications. This Edelbrock cam kit produced 367 HP & 340 ft-lbs. of torque when used with #7121 intake and #60259 cylinder heads on a 302 engine. The camshaft works well with high-performance street applications, Performer RPM cams provide power from 1500 to 6500 rpm. This hydraulic lifter camshaft is dyno-matched to Performer RPM manifolds for high-rpm horsepower while still maintaining acceptable low-end torque. With 10 to 12 inches of manifold vacuum at idle, Performer RPM cams have more lift and duration than most street camshafts. Hydraulic flat tappet lifters are included with each Performer RPM camshaft. Camshaft Specifications: 芒鈧垄 Duration @ .050 Intake: 224 degrees 芒鈧垄 Duration @ .050 Exhaust: 234 degrees 芒鈧垄 Lift @ Valve Intake: .496芒鈧聺芒鈧垄 Lift @ Valve Exhaust: .520芒鈧聺芒鈧垄 Lobe Separation: 112 Degrees 芒鈧垄 Intake Centerline: 107 Degrees 芒鈧垄 Idle Vacuum @ 1000 RPM's: 11芒鈧聺

More Information

More Information
Manufacturer	Edelbrock
Application	Application Specific
UPC	00085347071227
Lifter Materials	Hardened Steel
Computer Controlled Compatible	No
Intake Duration .050 Inch Lift	224 deg
Availability Note	Available to Order
Warranty	12 Months
Emissions Code
Hazardous Materials Warning	WARNING: This product can expose you to Chromium, which is known to the State of California to cause cancer or birth defects or other reproductive harm. For more information, visit www.P65warnings.ca.gov.
Installation Notes	Recommended Valve Springs for OEM heads: Edelbrock part # 5722 Not for 1985-later engines with roller lifters. Screw-in studs, guide plates and adjustable rocker arms required. For non-computer controlled vehicles Use only stock ratio rocker arms Adjustable valvetrain required In order for this Performer RPM cam and lifter kit to be covered under ANY WARRANTY you MUST use the correct Edelbrock Sure Seat Valve Springs or equivalent. Do not use rotator type valve springs or retainers for this application. Oil/additive must contain Zinc designed for use with flat tappet camshafts. Coat cam lobes and bottoms of each lifter with MoS2 lube (supplied) to prevent cam lobe and lifter wear from occurring during initial start-up. Do not allow the engine to run under 2000 rpm for the first 1/2 hour. Slow idle speeds may result in severe cam and lifter wear. Start the engine and bring to break-in rpm.
Advertised Exhaust Duration	300 deg
Advertised Intake Duration	290 deg
Intake Valve Lift	0.496 in
Lifter Type	Hydraulic
Lobe Separation	112 deg