Stars & Stripes Sale on American-Made MuscleShop Now

Performer Intake Manifold for 1970-91 AMC, Non-EGR, Satin Finish

was $424.95 Special Price $382.46
Edelbrock Performer AMC Intake Manifold for 1970 and Later 304-401 c.i.d. AMC V8 Engines is Designed for use with 4150-Style Square-Bore Carburetors. (Will not accept stock Motorcraft Carburetor). Non-EGR
In stock
Edelbrock Part # 2131 Performer AMC intake manifold is designed for 1970-91 street 304-360-401 c.i.d. V8 engines. Will not accept stock Motorcraft spread-bore carburetor. Edelbrock's Patented Dual-plane, low-rise design with a 180-degree firing order greatly improves torque over a wide rpm range for excellent throttle response from off-idle through 5500rpm. The Performer intake manifolds are ideal for passenger cars, trucks, 4x4s, tow vehicles and RVs.
More Information
Manufacturer Edelbrock
Application Application Specific
UPC 00085347021314
Series Performer
Gasket Or Seal Included No
Vehicle Model AMC/Jeep
Availability Note Available to Order
Warranty 12 Months
RPM Range Idle-5500 RPM
Emissions Code
Hazardous Materials Warning WARNING: This product can expose you to Lead, which is known to the State of California to cause cancer or birth defects or other reproductive harm. For more information, visit
Installation Notes
  • Recommended intake gasket: Edelbrock # 7213 Fel-Pro MS96011
  • Must use factory style metal valley tray
  • Manifold height: A-4.20", B-5.50"
  • Carb pad height: 4.85"
  • Requires # 8008 or # 8024 Stud, nut and washer kit.
  • Car recommendations: OEM 4-Bbl . Non-EGR square-bore Edelbrock AVS2 or Performer Series 500-650cfm.
  • Port exit dimensions: 1.03" x 2.07"
  • #2131 must use factory style metal valley tray.
  • Manifolds have two center bolt holes offset.
  • Edelbrock bracket #8034 required for 1979 and later vehicles.
  • Use RTV sealant to properly seal end seals, such as Edelbrock High Temp Silicone sealant # 1076, DO NOT USE END SEALS GASKETS.
  • Hardened washers Must be used with intake bolts to ensure proper torque and prevent galling of the aluminum.
  • Manifold will not accept factory Motorcraft spread-bore carburetors.
Finish Satin
Material Aluminum
Rear Maximum Height 5.500 in
Single Or Dual Plane Type Dual