We use cookies to provide you with the best possible user experience. By continuing to use our site, you agree to their use. To learn more, view our Cookie Policy.
Shift Out Of Summer Sale!Shop Now
Toggle Nav
Performer Smal Block Chevy 1987-95 Intake Manifold
was
$463.95
Special Price
$394.36
Edelbrock Performer Intake Manifold For Chevrolet 262-400 Small-Block V8 with1987-1995 Cast Iron Cylinder Heads
In stock
SKU
21043
The Edelbrock Performer #21043 intake manifold is designed for street 262-400 c.i.d. Chevy V8's that have heads with canted center bolt holes, 1987-1995. Edelbrocks Patented Dual-plane, low-rise design with a 180-degree firing order greatly improves torque over a wide rpm range for excellent throttle response. For 1987-95 stock aluminum heads use #2101. Will not fit Chevrolet Bowtie or LT1 heads. The Edelbrock Performer #21043 also features a durable black powder coated finish for long lasting protection and a distinctive look. For the ultimate "Made in USA" quality, every Edelbrock intake manifold is cast and machined in the USA.
Installation Notes:
• Recommended intake gasket: GM #10159409
• Manifold ht: A-3.50", B-4.60"
• Carb pad height: 4.05"
• Port exit dimensions: 1.14" x 1.88"
• Use RTV sealant to properly seal end seals, such as Edelbrock High Temp Silicone sealant #1076, DO NOT USE END SEALS GASKETS.
• Sealant must be used on intake bolt threads if the threads extend into lifter valley or coolant passage.
• NPT/Pipe thread fittings require the use of Teflon tape or paste on threads to ensure proper seal.
• DO NOT OVERTIGHTEN NPT/Pipe fittings, this may cause the aluminum to crack around the fitting boss. NPT/Pipe thread is a tapered thread.
• Hardened washers Must be used with intake bolts to ensure proper torque and prevent galling of the aluminum.
• Choke plate #8901 included
Installation Notes:
• Recommended intake gasket: GM #10159409
• Manifold ht: A-3.50", B-4.60"
• Carb pad height: 4.05"
• Port exit dimensions: 1.14" x 1.88"
• Use RTV sealant to properly seal end seals, such as Edelbrock High Temp Silicone sealant #1076, DO NOT USE END SEALS GASKETS.
• Sealant must be used on intake bolt threads if the threads extend into lifter valley or coolant passage.
• NPT/Pipe thread fittings require the use of Teflon tape or paste on threads to ensure proper seal.
• DO NOT OVERTIGHTEN NPT/Pipe fittings, this may cause the aluminum to crack around the fitting boss. NPT/Pipe thread is a tapered thread.
• Hardened washers Must be used with intake bolts to ensure proper torque and prevent galling of the aluminum.
• Choke plate #8901 included
WARNING: This product can expose you to Lead, which is known to the State of California to cause cancer or birth defects or other reproductive harm. For more information, visit www.P65warnings.ca.gov. 
Check items to add to the cart or
