Lunati HOT Summer Deals on Valve TrainShop Now

Heat Insulator Gasket for Open 4150 Square-Bore - 0.320" Thick

$31.95
The Edelbrock Square-bore Heat Insulator Gasket #9265 is designed to prevent percolation on Edelbrock Performer Series carburetors exposed to extreme under hood temperatures.
In stock
SKU
9265
The Edelbrock Square-bore Heat Insulator Gasket #9266 is designed to prevent percolation on Edelbrock Performer Series
carburetors exposed to extreme underhood temperatures. This gasket features an open center which will allow open plenum Torker
and Victorstyle manifolds to seal properly to the carburetor. Prior to installation, check air cleaner-to-hood clearance to ensure that additional height of heat insulator gasket will
not cause interference. Remove air cleaner and all attachments to the carburetor such as fuel line, throttle linkage, and vacuum
lines. Be sure to note the position or tag each piece to facilitate re-installation. Remove the carburetor and set it aside, then remove
the old base gasket and any additional plates, such as Edelbrock square-bore adapter #2732. Remove the short carb studs and
install the longer studs. Install the #9265 heat insulator gasket directly against the manifold, then replace the carb and all other connections. Note that gasket #9265 is rigid enough to replace square-bore adapter plate #2732, if required.
More Information
Manufacturer Edelbrock
Application Application Specific
UPC 00085347092659
Recommended Use Edelbrock Carburetors
Mounting Hole Quantity 4
Mounting Hole Diameter 0.35 in
Quantity Sold Individually
Barrel Quantity 4
Type Open Center
Availability Note Available to Order
Warranty 12 Months
Emissions Code N/A
Hazardous Materials Warning WARNING: This product can expose you to Chromium, which is known to the State of California to cause cancer or birth defects or other reproductive harm. For more information, visit www.P65warnings.ca.gov.
Material Nitrile Rubber Composite
Shape Square Bore
Thickness 0.320